Captura de pantalla 2015-12-04 a las 11.59.45

V200A-UMB | Wind/flow

Description

Descripción

Description:

V200A-Ultrasonic Wind Sensor, plastic housing and 20W-heater

Supplementary description:

Extremely precise and maintenance-free measurement of wind velocity and wind direction as well as calculation of acoustic virtual temperature. The ultrasonic wind sensor is designed without mechanical parts as they have been used with traditional “cups and vanes”. The digital or analog output delivers instantaneous, average, min or max value with flexible measuring rate. The V200A-UMB is heated in case reaching critical ambient conditions. Recommended for: meteorology or building automation. The following outputs/protocols are available: NMEA, ASCII, UMB and 4.. 20 mA analog.

Dimensions Ø approx. 150 mm, height approx. 170 mm
Weight Approx. 0.8kg
Permissible ambient temperature -40…60°C (with heating)
-20…60°C (without heating)
with heating 24 VDC, max. 20 VA
Bus operation Up to 32 devices
Operating voltage electronics 24 VDC ±10 % or 24 VDC/1.2 VA
without heating 12 VDC
Electrical connection 8 pole plug
Housing material Plastic
Protection type IP66
Pole diameter 50mm / 2″
Factory certificate Yes
Data output digital
Interface RS485 semi-/full duplex, isolated
Baud rate 1200-57600
Measurement rate instantaneous value 1-10s
Measurement Avg (arithmetic, vector), Min, Max 1…10min
Status Heating, sensor failure
Data output analog
Data output analog Only semi-duplex mode
Output signal 0…20 mA, 4…20 mA, 0…10V, 2…10V,
2…2,000 frequency (instantaneous, avg, min, max)
Load Max. 300 Ohm
Resolution 16 bit
Maximum operating height 3500m